We service both gas and electric furnace systems with manufacturer-trained technicians.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
Our technicians treat every furnace repair call in Riverside, CT the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
We carry manufacturer service manuals for major furnace brands.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
No-heat calls during freeze warnings get moved to the front of the schedule.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Riverside, CT.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Riverside, CT.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. This is one of the most requested furnace repair calls we get across Riverside, CT.
A furnace that runs but never blows warm air often traces to a blower motor or limit switch fault. This is one of the most requested furnace repair calls we get across Riverside, CT.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Riverside, CT.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Yes — our technicians are trained and certified on both fuel types.
Gas odor calls receive top dispatch priority.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Riverside, CT to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Riverside Service